How To Straighten Your Hair With Hair Bands - smartesthairstyles.com - Many of us love the look of straight hair, but some don't want heat damage, don't have a flat iron handy, or just don't have time to style it that way. Read on if you are looking for an easy way to straighten your hair without heat!
Steps by Steps :
1. Wash your hair the night before. It is important that you do this so that your hair is damp and clean.
2. Do not blow dry your hair after showering. Make sure your hair is wet, then towel dry until damp. It shouldn't be soaking wet, but it shouldn't be dry either.
3. Depending on the length of your hair, have 20-50 elastic hair bands ready. DO NOT use rubber bands, only those with a fabric outer sheath to avoid damaging your hair.
4. Divide your hair into 2-4 equal sections. If you have thin hair use 2. If you have thicker hair use 4.
5. Start with a section. Clip/tie the others back. Take a hair elastic and tie the section as you normally would to make a ponytail at about ear/nape level. Tie another just below the first one without leaving any gaps until you reach the end of the section. Try not to let hair stick out.
6. Repeat the last step on all sections. Be careful and watch out for stray hairs.
7. Go to bed. Get a good night's sleep with your bands!
8. Get up early in the morning when you need extra styling. If you did it right, your hair should be straight! Of course, it won't be straight as if you used a flat iron, but it should look the way you want it. There will most likely be a dent near your ears and neck where the first ribbon was tied. To avoid this, use softer ribbons at the top of your sections.
9. Add some hairspray or anti-frizz if needed. Frizz-prone hair might go a little crazy, but this can keep it under control.
10. Enjoy your straight hair! The more you practice this method, the better your results will be!
